incident id to use as parameter when calling a script

Question

Question by Dennis M. · Jul 06, 2015 at 07:49 PM ·

incident id to use as parameter when calling a script

Hi,

referring to , where I see that dynatrace must somehow create an incident ID for every incident.

quick question: can I use the incident ID somehow as part of calling a SNMP script?

E.g. I found this list of parameters to use Integrating dynaTrace into other tools with SNMP v2. When e.g. using ${Message} it works perfectly within calling the script. But how could I use the incident ID ? E.g. from the referred list, I cannot find anything like "incident_id". There is only a "session_id" which did not help me...

Best regards,
Dennis

0

10 |2000000 characters needed characters left characters exceeded

Attachments: Up to 10 attachments (including images) can be used with a maximum of 50.0 MiB each and 250.0 MiB total.

Answer 1 · 2015-07-06T20:55:20Z

Answer by Dennis M. · Jul 06, 2015 at 08:55 PM

Hi Graeme,

awesome, thanks! (smile)

Best regards,
Dennis

0 Show 1 · Share

10 |2000000 characters needed characters left characters exceeded

Attachments: Up to 10 attachments (including images) can be used with a maximum of 50.0 MiB each and 250.0 MiB total.

Dennis M. · Jul 07, 2015 at 01:33 PM 0

Share

"Key" is exactly what I was looking for. Thank you very much!

Answer 2 · 2015-07-06T20:20:09Z

Answer by Graeme W. · Jul 06, 2015 at 08:20 PM

Dennis,

It's ${Key}.

-- Graeme

0 · Share

10 |2000000 characters needed characters left characters exceeded

Attachments: Up to 10 attachments (including images) can be used with a maximum of 50.0 MiB each and 250.0 MiB total.

incident id to use as parameter when calling a script

2 Replies

Join the conversation!

NAM 2019 SP3 is available

LIVE WEBINAR

Follow this Question

Forum Tags