AMD interface shows "N" under link detected but no alarm

Question

Question by Taral P. · Oct 28, 2014 at 11:06 PM ·

AMD interface shows "N" under link detected but no alarm

Hi,

When running capture via RUM console on AMD, I came to know that one of interface was showing disconnected. When logged on to AMD, i could see that that AMd interface was set to capture traffic but under link detected, I can see "N".

My questions, what alert this should generate? So far, I can not see any alert which specify this event.

appreciate your kind response.

Thanks

0

10 |2000000 characters needed characters left characters exceeded

Attachments: Up to 10 attachments (including images) can be used with a maximum of 50.0 MiB each and 250.0 MiB total.

Answer 1 · 2014-10-30T02:11:05Z

Answer by Adam P. · Oct 30, 2014 at 02:11 AM

Taral,

Open /usr/adlex/log/rtm_perf.log and look for something similar to:

AL	Alarms 
AL	No traffic on monitoring interfaces:eth2 eth3 - check configuration or cables.

around the time when it happened.

0 Show 2 · Share

10 |2000000 characters needed characters left characters exceeded

Attachments: Up to 10 attachments (including images) can be used with a maximum of 50.0 MiB each and 250.0 MiB total.

Taral P. · Oct 30, 2014 at 02:37 PM 0

Share

Hi Adam,

Thanks. Does this type of alert generate SNMP trap and can it be reported to monitoring system? I can see that above is manual job to check on AMD itself but we would be much interested in automatic alarm trigger to say that AMD has seen disconection on its interface.

Adam P. &. Taral P. · Oct 30, 2014 at 04:09 PM 0

Share

Sure, take a look at Configuring SNMP Traps on AMD and SNMP Traps in Agentless Monitoring Device.

AMD interface shows "N" under link detected but no alarm

1 Reply

Join the conversation!

NAM 2019 SP3 is available

LIVE WEBINAR

Follow this Question

Forum Tags