TCP and UDP Unknown

Question

Question by Lam S. · Oct 31, 2014 at 10:29 AM ·

TCP and UDP Unknown

Hi Folks,

I'm on a POC and network traffic shows lots of TCP and UDP unknown in software services.

I know DCRUM has a Port Finder system but not quite sure how to tune the parameters to get the proper result. Should I decrease the value of "Min. number of sessions" and "Min. volume to monitor " so that DCRUM can put the traffic into "tracked"?

Much appreciated.

Sylvian

0

10 |2000000 characters needed characters left characters exceeded

Attachments: Up to 10 attachments (including images) can be used with a maximum of 50.0 MiB each and 250.0 MiB total.

Answer 1 · 2014-11-01T04:10:53Z

Answer by Adam P. · Nov 01, 2014 at 04:10 AM

Sylvian,

There are no "good" values for these settings as it depends on the environment you're in. PortFinder is intended to find candidates for Software Services that the customer is not aware and you just did not configured it as regular Software Service.

Also take a look at Configuring and Fine-Tuning the Port Finder

0 · Share

10 |2000000 characters needed characters left characters exceeded

Attachments: Up to 10 attachments (including images) can be used with a maximum of 50.0 MiB each and 250.0 MiB total.

TCP and UDP Unknown

1 Reply

Join the conversation!

NAM 2019 SP3 is available

LIVE WEBINAR

Follow this Question

Forum Tags