question

Thomas B. avatar image
Thomas B. asked ·

Verification of transaction run times complete...

After updating robots to 12.5.3 at the end of executing the scripts the following message is shown

and it rests 2 minutes on screen until finishing the script.

Any idea why this takes so long?

esm
robot.jpg (3.5 KiB)
10 |2000000 characters needed characters left characters exceeded

Up to 10 attachments (including images) can be used with a maximum of 50.0 MiB each and 250.0 MiB total.

Thomas B. avatar image
Thomas B. answered ·

Update to SP4 solved this problem now

Share
10 |2000000 characters needed characters left characters exceeded

Up to 10 attachments (including images) can be used with a maximum of 50.0 MiB each and 250.0 MiB total.

Yuriy L. avatar image
Yuriy L. answered ·

@Thomas B.

The status message displayed by the Framework stays up until either closed, or replaced by the next message. Like status indicators that can be found in many other software products, while it gives some idea of "what is going on", it is not always an accurate representation of what is going on. The message "Verification of transaction run times complete..." means that the Framework has finished verifying that all opened transaction have been closed and that time has been calculated for these transactions. Whether or not any problems have been found, the script needs to perform other actions, such as making sure that there are no processes running upon completion of the script that were not running before the script started, unless such "left-over" has been configured as permissible. These further steps can take two minutes or even more.

The fact that this message stays just means that it has not been removed or replaced. It, per se, does not indicate any problems with the script execution, and you can just ignore it. But if you see anything wrong with the script execution, or just want to dot all i's and slash all t's, please open a support ticket.

Thank you,

Yuriy

Share
10 |2000000 characters needed characters left characters exceeded

Up to 10 attachments (including images) can be used with a maximum of 50.0 MiB each and 250.0 MiB total.