Filtering the Visits by UserExperience Dashboard

Question

Question by Paul S. · Aug 06, 2015 at 05:04 PM ·

All,

Is there anyway I can filter out visits that only have 1 user action?

I have this so far:

ClientFamily != 'Googlebot/2.1' AND Duration > 300

but it still shows loads of single page request.

Regards,

Paul

0

10 |2000000 characters needed characters left characters exceeded

Attachments: Up to 10 attachments (including images) can be used with a maximum of 50.0 MiB each and 250.0 MiB total.

Answer 1 · 2015-08-06T18:19:38Z

Best Answer

Answer by Graeme W. · Aug 06, 2015 at 06:19 PM

Paul,

You're trying to put a filter on the Visits dashboard, is that correct?

Try: BounceRate=0 and State<>"In Progress"

Let us know if that works for you!

-- Graeme

0 · Share

10 |2000000 characters needed characters left characters exceeded

Attachments: Up to 10 attachments (including images) can be used with a maximum of 50.0 MiB each and 250.0 MiB total.

Answer 2 · 2015-08-07T08:58:08Z

Answer by Paul S. · Aug 07, 2015 at 08:58 AM

Graeme,

Ignore, I am being an idiot! All visits in the last 15 minutes will be in progress due to my Visits end after setting of 30 minutes.

Thanks again.

Paul

0 · Share

10 |2000000 characters needed characters left characters exceeded

Attachments: Up to 10 attachments (including images) can be used with a maximum of 50.0 MiB each and 250.0 MiB total.

Answer 3 · 2015-08-07T08:53:46Z

Answer by Paul S. · Aug 07, 2015 at 08:53 AM

Graeme,

The BounceRate=0 works great for old (finished) visits but the State<>"In Progress" always shows 0 visits.

Thanks for the BounceRate info, this is something that is blindinly obvious when you actually think about it.

Paul

0 · Share

10 |2000000 characters needed characters left characters exceeded

Attachments: Up to 10 attachments (including images) can be used with a maximum of 50.0 MiB each and 250.0 MiB total.