Purepath - Default Application

Question

Question by Régis E. · Aug 13, 2012 at 11:02 PM ·

Purepath - Default Application

Hello,

We have noticed that when the Purepath is in state "Unable to determine PurePath success because of the following reason(s)", the application is marked as "Default Application".
Is it normal? We are in Dynatrace 4.0

Thanks

0

10 |2000000 characters needed characters left characters exceeded

Attachments: Up to 10 attachments (including images) can be used with a maximum of 50.0 MiB each and 250.0 MiB total.

Answer 1 · 2012-08-14T16:25:56Z

Answer by Régis E. · Aug 14, 2012 at 04:25 PM

Hello Klaus,

Thank you for your response.
I give you a dynatrace session, if you can just have a look.

purepath.dts

Thanks

0 Show 1 · Share

10 |2000000 characters needed characters left characters exceeded

Attachments: Up to 10 attachments (including images) can be used with a maximum of 50.0 MiB each and 250.0 MiB total.

Klaus E. &. · Aug 14, 2012 at 06:58 PM 0

Share

The PurePath in your session reached the Default Time out limit of 10 minutes and was therefore marked as incomplete.

Klaus

Answer 2 · 2012-08-14T15:05:32Z

Answer by Klaus E. · Aug 14, 2012 at 03:05 PM

Hi,
With dynaTrace 4.0 we have introduced the application concept. All PurePaths that do not belong to a specific application end up in the "Default Application". So if I got you right then something goes wrong with the application detection. Can you export a session with such PurePaths?

Klaus

0 · Share

10 |2000000 characters needed characters left characters exceeded

Attachments: Up to 10 attachments (including images) can be used with a maximum of 50.0 MiB each and 250.0 MiB total.

Purepath - Default Application

2 Replies

Join the conversation!

NAM 2019 SP3 is available

LIVE WEBINAR

Follow this Question

Forum Tags