Incident based on "Last Run" outcome

Question

Question by Jan S. · Dec 04, 2012 at 05:22 PM ·

Incident based on "Last Run" outcome

Hello,

is it possible to trigger an incident on the outcome of the "Last Run" of a monitor? E.g., when the Last Run failed, send an email.

Thanks
J

0

10 |2000000 characters needed characters left characters exceeded

Attachments: Up to 10 attachments (including images) can be used with a maximum of 50.0 MiB each and 250.0 MiB total.

Answer 1 · 2012-12-05T03:27:48Z

Answer by Andreas G. · Dec 05, 2012 at 03:27 AM

Incidents are triggered by Measure Values that exceed the defined Threshold. So - if you have a measure that indicates whether a monitor "fails" or not then this should be possible.
All you need to do is to set the Evaluation Timeframe to e.g: 10 seconds and the aggregation column of the measure to "Last". That makes sure that dynaTrace automatically evaluates the last measured value that is returned by your monitor and then triggers the incident. hope this makes sense.

For more information on Incidents I also recommend the dynaLearn Webinar we did on that topic: dynaLearn Webinar - Incidents, Alerts and SLAs - September 26, 2012

0 · Share

10 |2000000 characters needed characters left characters exceeded

Attachments: Up to 10 attachments (including images) can be used with a maximum of 50.0 MiB each and 250.0 MiB total.

Incident based on "Last Run" outcome

1 Reply

Join the conversation!

NAM 2019 SP3 is available

LIVE WEBINAR

Follow this Question

Forum Tags