Verification of transaction run times complete...

@Thomas B.

The status message displayed by the Framework stays up until either closed, or replaced by the next message. Like status indicators that can be found in many other software products, while it gives some idea of "what is going on", it is not always an accurate representation of what is going on. The message "Verification of transaction run times complete..." means that the Framework has finished verifying that all opened transaction have been closed and that time has been calculated for these transactions. Whether or not any problems have been found, the script needs to perform other actions, such as making sure that there are no processes running upon completion of the script that were not running before the script started, unless such "left-over" has been configured as permissible. These further steps can take two minutes or even more.

The fact that this message stays just means that it has not been removed or replaced. It, per se, does not indicate any problems with the script execution, and you can just ignore it. But if you see anything wrong with the script execution, or just want to dot all i's and slash all t's, please open a support ticket.

Thank you,

Yuriy