question

Wong S. avatar image
Wong S. asked ·

Is it possible to show the ProcessId of a process ?

Is there a setting to Dynatrace SaaS to show the processId ?

dynatrace saasprocess groups
10 |2000000 characters needed characters left characters exceeded

Up to 10 attachments (including images) can be used with a maximum of 50.0 MiB each and 250.0 MiB total.

Michael K. avatar image
Michael K. answered ·

little tricky but yes, if you see a further detail button then the pid is shown at the top.

please raise a product idea for this it would be a good idea to have the last pid in the process properties.

Share
10 |2000000 characters needed characters left characters exceeded

Up to 10 attachments (including images) can be used with a maximum of 50.0 MiB each and 250.0 MiB total.

Wong S. avatar image
Wong S. answered ·

Thanks Michael for your reply, I will raise as a product idea but just to check this is further detail that you refer to right


capture.png (13.9 KiB)
1 comment Share
10 |2000000 characters needed characters left characters exceeded

Up to 10 attachments (including images) can be used with a maximum of 50.0 MiB each and 250.0 MiB total.

I think he actually means that, when you have an instrumented process, you click on the "Further details" metrics tab underneath the infographic. Then, you will see a "Process identifier" at the top of that page.


0 Likes 0 · ·