cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Port opening for Active gate in Dynatrace SaaS

sangeetha_mitta
Organizer

Could you please clarify on the below? (dummy ip address are mentioned below)

Active gate VM Has 3
IPs.

IP in VLAN -123.11.11.23

IP Patio - 342.144.145.37

Public IP address in DMZ - 222.218.27.88

we have raised
firewall port from source 123.11.11.23(IP IN VLAN) to SAAS tenant with 8443 port.

Is this
correct or do we need to select source IP as 222.218.27.88(public IP in DMZ) instead
172.21.14.73.

Thanks&Regards

Sangeetha


2 REPLIES 2

Radoslaw_Szulgo
Dynatrace Guru
Dynatrace Guru

If you run multiple NICs define the communication NIC by defining that in config.properties file. Set bindToNetworkInterface property under section [connectivity]


Then restart AG.
Senior Product Manager,
Dynatrace Managed expert

ChadTurner
DynaMight Legend
DynaMight Legend

Review the following document as what ports need to be open depending on your use case: https://www.dynatrace.com/support/help/setup-and-configuration/dynatrace-activegate/configuration/wh...


-Chad

Featured Posts